34.12.6.1 switch port gvrp disable Command
Syntax:
switch port gvrp disable <giga-port>
This command turns off GVRP on a Gigabit Ethernet interface.
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network. Disable GVRP to
have the system not propagate VLAN information to other devices.
The following example turns off GVRP on the subtending 1 Gigabit Ethernet interface.
ras> switch port gvrp disable sub1
34.12.6.2 switch port gvrp enable Command
Syntax:
switch port gvrp enable <giga-port>
This command turns on GVRP on a Gigabit Ethernet interface.
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network. The system
propagates VLAN information to other devices when you enable GVRP.
The following example turns on GVRP on the subtending 1 Gigabit Ethernet interface.
ras> switch port gvrp enable sub1
34.12.7 switch port mode Command
Syntax:
switch port mode sub1|sub2|up1|up2 <uplink|subtend>
This command sets a Gigabit Ethernet interface to function as uplink or subtending.
The following example sets the subtending 1 Gigabit Ethernet interface to uplink mode.
ras> switch port mode sub1 uplink
34.12.8 switch port mstp Commands
Use the
switch port mstp
Gigabit Ethernet interfaces.
34.12.8.1 switch port mstp disable Command
Syntax:
switch port mstp disable sub1|sub2|up1|up2|all <mstid>
where
MSC1000G/1024G/1224G Series User's Guide
commands to configure multiple spanning tree settings for the
=
A unique number to identify an MST region. Enter 0 to for CIST.
<mstid>
For MSTI, enter a number between 1 and 16.
Chapter 34 switch Commands
897