Switch Port Setup Broadcast Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 15 Switch Screens
Figure 344 Switch Port Setup: Bandwidth
The following table describes the labels in this screen.
Table 253 Switch Port Setup: Bandwidth
LABEL
Port
Enable
Ingress Rate
Egress Rate
Apply
Cancel

15.15 Switch Port Setup Broadcast Screen

Click Switch > Switch Port Setup > Broadcast in the navigation panel to display the screen
shown next. Use this screen to configure broadcast storm control settings for the Gigabit
Ethernet interfaces.
Figure 345 Switch Port Setup: Broadcast
494
DESCRIPTION
This is the label of a Gigabit Ethernet interface.
Select this check box to turn on bandwidth control for an interface.
Type a maximum bandwidth allowed for the incoming traffic flow on a port
(measured in megabits per second). Use a number from 0 to 1000.
Type a maximum bandwidth allowed for the out-going traffic flow on a port
(measured in megabits per second). Use a number from 0 to 1000.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MSC1000G/1024G/1224G Series User's Guide