Cluster Vlan Command - ZyXEL Communications MSC1024G Series User Manual

The following is an example.
ras> cluster show
mode
vlan
name
member list:
id state
-- -------- --------------- ------------- ---------------- -----------------
1 active
2 -
3 -
4 -
5 -
6 -
7 -
8 -
where
mode
vlan
name
member list
id
state
hostname
uptime
model
mac

24.2.11 cluster vlan Command

Syntax:
cluster vlan <vid>
where
MSC1000G/1024G/1224G Series User's Guide
:manager
:4094
:Manager-A
hostname uptime
= Whether this device is the manager of the cluster or a member.
This is the VLAN ID that the cluster uses and is only applicable if the
=
manager DSLAM is set to use IEEE 802.1Q VLAN. All DSLAMs must be
directly connected and in the same VLAN group to belong to the same
cluster. This field is ignored if the clustering manager is using port-based
VLAN.
= This is the name of the cluster.
This table lists the DSLAMs that belong to the cluster.
=
The DSLAM's ID number in the cluster. 1 is the cluster manager.
=
= This column displays the status of this DSLAM within the cluster.
active: The member is fine.
inactive: The manager can not communicate the member.
waiting: The manager has sent a command to add the member and is
waiting for a response.
error: The member reported that the password was wrong.
This is the cluster DSLAM's system name.
=
= This is how long the DSLAM has been turned on and in the cluster.
= This field displays the model name of the DSLAM.
This is the DSLAM's hardware MAC address.
=
= This is the cluster management VLAN ID. The cluster's DSLAMs must be
<vid>
directly connected and in the same VLAN group. The cluster
management VID must be different from the management VID.
Chapter 24 cluster Commands
model
02:20:38 IES-5000
mac
00:13:49:d1:d0:bc
627