Multicast Igmpcount Show Command; Multicast Igmpfilter Commands; Multicast Igmpfilter Set Command - ZyXEL Communications MSC1024G Series User Manual

The following command sets a IGMP count limit of 2 for DSL port 4 on the line card in slot 3.
ras> multicast igmpcount set 3-4 2

30.8.4 multicast igmpcount show Command

Syntax:
multicast igmpcount show <slot>
This command displays the IGMP count limit setting status for the DSL ports on the line card
in the specified slot. The following example displays the IGMP count limit settings for the
ports on the line card in slot 3.
ras> multicast igmpcount show 3
[slot9] igmpcount
port enable count
----- ------ -----
3- 1 -
3- 2 -
3- 3 -
3- 4 -
3- 5 -
3- 6 -
-------------------------- [snip] --------------------------
3-44 -
3-45 -
3-46 -
3-47 -
3-48 -

30.9 multicast igmpfilter Commands

Use the IGMP filter commands to define IGMP filter profiles and assign them to DSL ports.
IGMP filter profiles allow you to control access to IGMP multicast groups. You can have a
service available to a specific IGMP multicast group. You can configure an IGMP filter profile
for an IGMP multicast group that has access to a service (like a SIP server for example). Then
you can assign the IGMP filter profile to DSL ports that are allowed to use the service.

30.9.1 multicast igmpfilter set Command

Syntax:
switch igmpfilter set <slot-port> <igmpfilter>
where
<igmpfilter>
This command sets an ADSL port(s) to use an IGMP filter profile.
MSC1000G/1024G/1224G Series User's Guide
5
5
5
5
5
5
5
5
5
5
5
= The name of an IGMP filter profile.
Chapter 30 multicast Commands
679