Ip Bridge Routes Screen - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Table 181 IP Bridge Interfaces (continued)

14.9 IP Bridge Routes Screen

Use this screen to look at the routing table for a domain. This table includes all the entries,

whether added automatically by the system or provided manually.

To open this screen, click Statistics > IP Bridge > Route.

Figure 268 IP Bridge Routes

The following table describes the labels in this screen.

Table 182 IP Bridge Routes

Interface IP

MSC1000G/1024G/1224G Series User's Guide

This field displays the line card's port number to which the device is connected.

It displays "-" if the system looks for the subscriber in the whole VLAN and not a

specific PVC.

This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier

(VCI), if any. The VPI and VCI identify a channel on this port.

This field specifies whether the downlink interface is running on Ethernet (ipoe)

or on ATM (ipoa).

Select a domain for which you wish to view information and click Load to

This field displays the number of the entry.

This field displays the name of the domain to which this entry applies.

These fields display the IP address and the number of bits in the subnet mask

that define the range of IP addresses to which this entry applies. If the

destination IP address of a packet is in this range, the system forwards the

frame to the specified edge router.

This field displays the IP address to which the system forwards frames if the

destination IP address of a packet is in the specified range. It displays "-" if the

field does not apply to the entry (for example, in entries created automatically by

the system).

This field displays the "cost" of transmission for routing purposes. It displays "-"

if the field does not apply to the entry (for example, in entries created

automatically by the system).

Chapter 14 Statistics Screens

Msc1224g series Msc1000g series