ZyXEL Communications MSC1024G Series User Manual page 879

where
re
<mep-id>
<direction>
<priority>
<cci-enabled>
<alarm-time>
<reset-time>
This command configures a maintenance end point (MEP).
The example identifies the port 22 in slot 2 using the MEP ID 22 and the port will send CCMs
with priority 7.
ras> switch cfm mep set MD1 MA1 22 2-22 down 7 cci on
ras> switch cfm show MD1 MA1
maintenance association : MA1
cci interval
primary vlan
no. of maintenance ep
maintenance ep list
vlan list
MEP id slot-port direction Priority cciEnabled
------ --------- --------- -------- ----------
22
mip:
34.5.3.16 switch cfm mip delete
Syntax:
switch cfm mip delete <md-name> <ma-name> <giga-port>|<slot-port>
This command deletes a maintenance association intermediate point. The following shows an
example.
ras> switch cfm mip delete
34.5.3.17 switch cfm mip set
Syntax:
switch cfm mip set <md-name> <ma-name> <giga-port>|<sid> [mac]
MSC1000G/1024G/1224G Series User's Guide
The maintenance end point identifier.
= Choose up|down.
Specify whether to send CCMs (Connectivity Check Messages) from the
specified end point (down) or from (up). Select up only when the link of the
specified end point is down.
=
Specifies the priority of the CCMs sent from this CFM end point.
= Indicates whether to issue CCM or not (default is 0).
0: disabled
1: enabled
This is the number of seconds (2.5~10) the system waits to send a local
=
alarm after three times of CFM_ERROR detected. The default is 2.5
seconds.
= This is the number of seconds (2.5~10) the system waits to remove a local
alarm after CFM_ERROR has been resolved and no other alarms
occurred. The default is 10 seconds.
: 5
: 100
: 1
: 22
: 100
2-22 down
Chapter 34 switch Commands
7 enabled
879