Port Ipbpvc Interface Set Command; Port Ipbpvc Interface Show Command - ZyXEL Communications MSC1024G Series User Manual

where
<ip/mask>
<vid>
vpi/vci
This command creates the specified downlink interface. The
specifies the IP address and subnet mask of the VLAN or subscriber. If the destination IP
address of a packet is in this range, the system forwards the frame to the specified VLAN and
PVC, if any.
The system uses the specified VLAN ID when it forwards frames to the VLAN or subscriber.
It also uses the VLAN ID to identify the domain the downlink interface is in.
Make sure you specify a valid IP bridge PVC. Do not specify PVCs that are not
set as the IPB PVCs (see
The following example creates a downlink interface that forwards frames for IP addresses
192.168.3.0~192.168.3.255 to VLAN 402.
ras> port ipbpvc interface set 192.168.3.0/24 402

31.21.3 port ipbpvc interface show Command

Syntax:
port ipbpvc interface show all|<ip/mask>|<vid>|<ip/mask> <vid>
where
ip/mask
vid
This command displays downlink interfaces created manually. It does not show forwarding
information learned by snooping DHCP packets.
An example is shown next.
ras> port ipbpvc interface show 402
ip/mask
------------------ ---- ---- ---- --- ----
192.168.3.0/24
The output values correspond to the input values of other IP bridge downlink interface
commands.
MSC1000G/1024G/1224G Series User's Guide
Downlink interface's IP address, in dotted decimal notation and number
=
of bits <1..32> in the subnet mask.
The ID (<1..4094>) of the VLAN.
=
The VPI and VCI of an individual PVC.
=
Section 31.22.4 on page
Downlink interface's IP address, in dotted decimal notation and number
=
of bits <0..32> in the subnet mask.
The ID (<1..4094>) of the VLAN.
=
vid slot port vpi vci
402 - -
Chapter 31 port Commands
<ip-address>
728).
- -
/<mask>
725