SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Using the Statistics Command to
Display System Elements Status
Entering the Statistics Mode
General
7-4
Issue 4
June 2002
You can use the statistics command with the appropriate options to display
the configuration settings and the status of the following system elements
associated with the SLC ConnectReach system:
Internet protocol (IP)
3
Quality of service (QOS)
3
Address resolution protocol (ARP)
3
Internet control message protocol (ICMP)
3
Transport control protocol (TCP)
3
User datagram protocol (UDP)
3
Interfaces
3
Firewall
3
Network address translation (NAT)
3
Dynamic host configuration protocol (DHCP)
3
Point-to-point protocol (PPP)
3
T1 interface
3
Voice channels
3
Frame relay interface
3
Routing.
3
Most statistics displays give you a real-time view of counters for parameters in the
system. Others tell about interfaces, security, usage, and routing.
In addition to the statistics command, you can use syslog to create a log of
messages reporting significant events occurring on the SLC ConnectReach
system. See "Configuring SYSLOG" on page 4-146 for details.
363-208-050
(Continued on next page)