Lucent Technologies SLC ConnectReach User & Service Manual page 145

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Channel Bank Mode
(Continued)
Procedure
(continued)
™
System
Step Procedure
3
cont.
To
Set the tip status for all
unconfigured channels
Set the delay for loop-
ground disconnect
Set the line to transmit
message waiting signal
when on-hook
Load a configuration of a
channel
Write your changes to the
specified channels
Display channel-bank mode Show-all
Configure cross-connect
Access online assistance
4 If you are connected to the SLC ConnectReach system by means of a console
session or a Telnet session, enter the copy-to-channel-data command to
write your changes to the specified channel(s).
5 If you are accessing the SLC ConnectReach system Utility from a Web browser,
select the Update button to write your changes to the specified channel(s).
6 Repeat Steps 3, 4, and 5 to change the configuration for other channels or ranges
of voice channels, if appropriate.
7
Use the Show-all command to see the actual channel configuration.
8 At the Config:Channel-bank prompt, set the tip status for all unconfigured
channels using the unconfigured-state command. The unconfigured-
state command applies to all unconfigured channels.
Enter this ...and one of these
command... options
unconfigured-state [idle], busy
20...600...1200
lp-gnd-disc-delay msec
on-hook-tx on, [off]
load-template 1...24
copy-to-channel-
data
cross-connect
Help
(Continued on next page)
Issue 4
363-208-050
June 2002 4-59