Lucent Technologies SLC ConnectReach User & Service Manual page 412

Configure/Monitor and Upgrade Software for the SLC
ConnectReach System Using a Web Browser
Executing Commands from the Main Menu
Using a Web Browser to Reboot the SLC
ConnectReach System (Continued)
Performing a warm-
start reboot
(continued)
Performing a cold-
start reboot
8-24
Issue 4 June 2002
NOTE:
If you change the beginning channel number of any range in the DS0
Provisioning menu and do a warm-start, the system will automatically
prompt you that it will perform a cold-start.
Performing a cold-start command is the equivalent of cycling power to the
SLC ConnectReach system. All connections (both voice and data) are interrupted,
and new connections cannot be made during the time it takes for the hardware to
initialize and run the self-test routines and the system software to initialize and
read saved configuration information (approximately 35 seconds).
The cold-start command is used when an error condition can only be resolved
by completely reinitializing the SLC ConnectReach system. In addition, a cold
start is required if you change the starting channel of any range of voice or data
channels.
To initiate a cold-start command, click the cold-start command on the
SLC ConnectReach system Main Menu (shown in the previous figure). The SLC
ConnectReach system terminates your HTTP session and reboots.
363-208-050