Lucent Technologies SLC ConnectReach User & Service Manual page 395

Configure/Monitor and Upgrade Software for the SLC
ConnectReach System Using a Web Browser
Executing Commands from the Main Menu
Displaying Selected Menu Screens
(Continued)
Display config
submenu
(continued)
Step Procedure
2 In the Config submenu, click a command to change configuration settings
for that command.
For example, if you click the Network-t1 command in the Config
submenu, the parameters for configuring the network
T1/DSX-1 interface appear, as shown in the following figure. For details
about each configuration setting, refer to Chapter 4, "Configuring the
®
SLC ConnectReach
™
System".
363-208-050
(Continued on next page)
8-7
Issue 4 June 2002