Lucent Technologies SLC ConnectReach User & Service Manual page 252

®
Configuring the SLC ConnectReach
Reconfiguring the SLC ConnectReach System
Session Choices for Accomplishing
Reconfiguration (Continued)
Using a Telnet
session to
reconfigure and
monitor the SLC
ConnectReach
system
4-166 Issue 4 June 2002
™
System
Before you can use a Telnet session to configure the SLC ConnectReach system,
the unit must be as follows:
Connected to AC or DC power.
3
Initially configured for an Ethernet or Internet/T1 connection, including an
3
IP address, netmask, and broadcast address. For more information about
initial configuration, refer to the section entitled "Connection at the RS-232
port", located at the front of this chapter.
Connected to the network through an Ethernet or T1 connection. For
3
information about connecting cables, refer to Chapter 5, "Installation".
You must also have a computer that is connected to the same network as the SLC
ConnectReach system, or to a network from which access to the SLC
ConnectReach system is permitted.
On the computer, start a Telnet session and enter the IP address assigned to the
SLC ConnectReach system. Once the Telnet session is connected, the user
interface is identical to the console session shown in this chapter.
If a Carrier privilege login name has been configured, the SLC ConnectReach
system Utility displays a login prompt. After you enter a login name and password,
the Main Menu prompt appears, and the commands described in this chapter and
in Chapter 7, "SLC ConnectReach System Monitoring", become available.
363-208-050