Lucent Technologies SLC ConnectReach User & Service Manual page 195

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the DHCP Service
(Continued)
Procedure
(continued)
™
System
Step Procedure
3 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT)
NOTE: If you change any of these commands, you must save the
configuration and reboot the SLC ConnectReach system using the
warm-start command for the new settings to take effect.
Stop! End of Procedure.
When DHCP allocates an address to a requesting device, DHCP also notifies the
device about the address of the default gateway. Because the SLC
ConnectReach system is the default gateway, you do not need to configure this.
There should be only one DHCP server on a given subnet.
.
Issue 4 June 2002 4-109
363-208-050