®
Configuring the SLC
ConnectReach
Using the Configuration Commands
Configuring NAT and PAT (Continued)
Introduction
(continued)
Procedure
™
System
With static allocation, the translation between the LAN IP addresses and the WAN
IP addresses is a static one-to-one relation. Static translation may or may not
allow inbound connections from the WAN to the LAN. Pass-thru groups define
LAN IP addresses that are allowed to pass through the NAT firewall. The WAN
range must be a valid range.
NOTE:
If the firewall configuration, "IP filtering plus server" is to used in conjunction
with NAT, a static group with "allow-inbound enabled" for the server must be
set up in NAT. For examples on NAT configuration, see Appendix B, NAT
Examples on page B-18.
To configure NAT, proceed as follows:
Step
Procedure
1
At the config prompt, enter the NAT command:
( config)>
NAT
The prompt changes to the Config:NAT prompt.
( config:NAT )>
(Continued on next page)
Issue 4
June 2002
4-121
363-208-050