Lucent Technologies SLC ConnectReach User & Service Manual page 184

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Voice Mail (Continued)
Key commands
(continued)
4-98 Issue 4 June 2002
™
System
Direct-prefix This command specifies the DTMF digit required, if
any, that needs to be inserted before the extension
number. In most cases, this is an asterisk (refer to the
following figure.
Ring-no-answer This command specifies the DTMF string that signals
to the voice mail system that the line was ringing and
there was no answer. The string can include the
originator's and destination extension numbers.
Busy-no-answer This command specifies the DTMF string that signals
to the voice mail system that the line was busy. The
string can include the originator's and destination
extension numbers.
Forward-all This command specifies the DTMF string that signals
to the voice mail system that the destination is an
unknown location. The action by the voice mail system
in this case is often to give a message (for example,
"the extension you have dialed is not a valid extension,
please try again or dial zero for assistance").
MWI-on-prefix This command specifies the DTMF string to attach to
the user's extension indicating a message is waiting.
The information is coming from the voice mail system
to the SLC ConnectReach system.
363-208-050
(Continued on next page)