Lucent Technologies SLC ConnectReach User & Service Manual page 204

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Using ARP (Continued)
Procedure
(continued)
4-118 Issue 4 June 2002
™
System
Step Procedure
3 To display the table of all ARP mappings, use the Show-ARP-table
command. The results will appear as follows:
192.168.0.1 at 0:60:49:00:02:87
192.168.0.2 at 0:b0:d0:a5:c8:19
NOTE:
The new command values do not take effect until you save the
configuration and reboot the SLC ConnectReach system using the
cold-start command.
Stop! End of Procedure.
363-208-050