Lucent Technologies SLC ConnectReach User & Service Manual page 364

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for Voice Channels
(Continued)
Entering the voice-
states command
(continued)
7-30
Issue 4 June 2002
Switched Analog Trunks
Ch# CdA CdB Dest
--- --- --- --------
1 1 1
2 1 1
3 1 1
4 1 1
5 0 1 DigTrk 1 Active
6 1 1
7 1 1 DigTrk 2 Active
8 1 1
Channel Bank
DS0 SLIC# RxA RxB
--- ----- --- ---
1 1 0 1
2 2 0 1
3 3 1 1
4 4 1 1
5 5 1 1
6 6 1 1
7 7 1 1
8 8 1 1
If voice connections are not operating as expected, use the diagnose command,
discussed later in this chapter, to test the channel. In the diagnose mode, the
display will show statistics for states, such as diagnostic ringing, diagnostic
tone1k, etc.
State
-----
Idle
Idle
Idle
Idle
*05*12018889902
Idle
Idle
Dest State
-------- -----
Line 5 Active
Line 7 Active
Idle
Idle
Idle
Idle
Idle
Idle
363-208-050
(Continued on next page)