Lucent Technologies SLC ConnectReach User & Service Manual page 222

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Default Firewall
(Continued)
Viewing default
firewall
configuration
settings (continued)
Configuring custom
firewall
4-136 Issue 4 June 2002
™
System
The IP outbound filter group settings for the default IP filter plus server sample
configuration shown in the previous figure are as follows:
1Filter:
2Filter:
3Filter:
4Filter:
5Filter:
6Filter:
7Filter:
8Filter:
9Filter:
10Filter:
11Filter:
12Filter:
13Filter:
14Filter:
15Filter:
16Filter:
defaultAction permitAll
To see the inbound and outbound filters for a filter group, enter the show
command and the number of a filter group, for example:
(config:IPFirewall)>
Both the inbound and outbound filters will be displayed for that group.
For almost all SLC ConnectReach system users, the default configurations will be
sufficient. For custom IP firewall configurations, see Appendix C, Custom Firewall
Configurations
show 1
363-208-050