Displaying Statistics For Route - Lucent Technologies SLC ConnectReach User & Service Manual

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status

Displaying Statistics for Route

Entering the route
command
ConnectReach Routing Table
Network
1.0.0.0
13.0.0.0
14.0.0.0
100.0.0.0
200.200.100.0 255.255.255.0 207.242.96.176 2
200.200.200.0 255.255.255.0 207.242.96.176 1
207.242.96.0
213.213.213.0 255.255.255.0 213.213.213.1 1
0.0.0.0
Flags: D->Direct S->Static F->Default R->RIP
State: G->Good P->Suspect B->Bad
Total number of routes: 9
7-46
Issue 4 June 2002
The route command is used to display the routing table for the SLC
ConnectReach system.
At the statistics prompt, enter the route command:
(statistics)> route
A Route Net Table report similar to the following example is displayed, showing
the network IP address, the network mask, the Gateway ( GW — the IP address of
the next hop router), the Distance (or the number of hops) in the route, the
interface ( Intf — fr stands for Frame Relay and qu stands for Ethernet), the
flags, the status, and the number of interfaces that are referenced by the current
route:
Mask
255.0.0.0
255.0.0.0
255.0.0.0
255.0.0.0
255.255.255.0 207.242.96.201 1
0.0.0.0
GW Dist Intf Flags State Ref
1.1.1.1 2 fr0
207.242.96.201 1 fr0
207.242.96.201 1 fr0
207.242.96.1 1 qu0
qu0
qu0
qu0
fr1
207.242.96.201 0 fr0
(Continued on next page)
363-208-050
R G 1
S G 1
S G 1
S G 1
R G 1
S G 1
D G 2
D G 1
F G