Lucent Technologies SLC ConnectReach User & Service Manual page 242

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring FTP Log Dump
Introduction
Procedure
4-156 Issue 4 June 2002
™
System
The FTP Log Dump menu sets the FTP commands necessary to enable the
ftp-log-dump feature. If the SLC ConnectReach system has an abnormal
termination of the software, the FTP Log Dump downloads all pertinent
information as American standard code for information interchange (ASCII) text to
the designated location. The location is determined by the commands host,
filename, and directory. The remaining commands are for customer relevant
information. This information is tied in with the FTP Log Dump information and is
purely for identification purposes only.
The information that is gathered is useful in helping to debug the cause of the
abnormal software termination. The information provided includes all the relevant
identification type commands, as well as the configuration. The dump also shows
how the software terminated.
The password is never shown for security purposes.
Follow these steps to configure the Ftp-log-dump menu:
Step Procedure
1 At the Config prompt, enter the Ftp-log-dump command:
(config)> Ftp-log-dump
The prompt changes to the Config:Ftp-log-dump prompt.
(config:Ftp-log-dump)>
363-208-050
(Continued on next page)