Lucent Technologies SLC ConnectReach User & Service Manual page 244

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Setting Features
Introduction
4-158 Issue 4 June 2002
™
System
Certain features of the SLC ConnectReach system are enabled by entering a
feature key. This allows the SLC ConnectReach system to support different
feature sets with a single load image. The following table lists the features and
describes their functionality.
Feature
Data Module (SW-D)
LCR*/DID
BOX*
Auto-config
SLA
FT-1
DSP
ConnectReach
* Trademark of VINA Technologies, Inc.
The following table lists the Features commands.
Enter this command...
features-show
set-features
Functionality
Enables full data service through the 10BaseT Ethernet port.
Enables the Digital-Trunk, Analog-Trunk, Line, Map-
Extensions and Dialing menus.
Enables the Voice-Mail menu and the BOX-Features and
Feature-Codes commands under the Lines menu.
Enables the Auto-config feature.
Enables the SLA feature.
Enables the Fractional T1 card.
Enables the DSP card.
Enables the ConnectReach feature.
Comments
Displays the features that are enabled.
Sets feature key, which is enabled by entering a feature
number that is provided by Lucent Technologies.
363-208-050
(Continued on next page)