Installation
About This Chapter
Introduction (Continued)
Standard system
Optional mounting
hardware
The following items are included in the SLC ConnectReach system.
SLC ConnectReach system unit
3
Two mounting brackets [used for mounting the unit on the wall or in an
3
American national standards institute (ANSI) 19- or 23-inch relay rack]
Eight screws for attaching the mounting brackets to the unit
3
Four screws for mounting the unit to a rack
3
120 V AC power supply or DC cable
3
Rubber feet for desktop mounting
3
10-foot T1 modular shielded cable (RJ-48C) for network T1/DSX-1
3
connection.
The following orderable mounting hardware can be used as an alternative to the
standard mounting brackets provided with the SLC ConnectReach system unit:
Two mounting brackets, similar to the standard mounting brackets, for
3
mounting the unit in a Bellcore relay rack. The eight screws for attaching
the mounting brackets to the unit and the four screws for mounting the unit
to the rack are also provided.
A hinged mounting assembly that mounts to the wall and offers the ability
3
to swing away from the wall to provide access to a maximum of four units.
After the first unit is mounted on the assembly, extension brackets are used
to mount the additional units.
Refer to document 363-208-000, SLC-2000 Access System, Application,
Planning, and Ordering Guide, for information on ordering the optional mounting
hardware.
363-208-050
Issue 4
June 2002
5-5