Lucent Technologies SLC ConnectReach User & Service Manual page 267

Installation
Interface Card Installation
Optional Circuit Card Installation
(Continued)
Fractional T1
circuit card
installation
procedure
(continued)
Step Procedure
5 Refer to the following figure showing the top view of the motherboard to
locate where the card is to be installed and identify the connectors that
will be involved.
6 Remove the jumper block from header P31 located on the motherboard.
7 Align the connectors on the bottom of the fractional T1 card with the
connector pins on the motherboard and gently press on the top of the
card until the card locks in place over the plastic standoff pins.
363-208-050
(Continued on next page)
Issue 4 June 2002 5-15