Lucent Technologies SLC ConnectReach User & Service Manual page 514

PVC Configuration for ENAT
(Continued)
Procedure
(continued)
-XQH 
F-8
Issue 4
Step Procedure
2 At the config:Frame-relay prompt, enter PVC n where n is any number
from one to thirty.
(config:Frame-relay)> PVC 1
The prompt changes to the config:FrameRelay:PVC1 prompt.
( config:FrameRelay:PVC1 )>
3 At the config:FrameRelay:PVC1 prompt, enter the ip-address command,
and either enet (to assign the primary Ethernet IP address for NAT
incoming or pass-through), or the WAN IP address for NAT outgoing.
4 Enter the NAT command, and one of the following options;
PASS – allows all IP packets to pass through (incoming and
outgoing) on the designated PVC; typically used to bypass the
NAT firewall for management access.
IN – allows incoming IP packets only for the specified PVC;
typically used for WAN access by a workstation in a remote office
OUT – allows outgoing IP packets only for the specified PVC;
typically used for WAN access by a workstation on a local LAN.
Stop! End of Procedure.
363-211-129
Appendix E