Lucent Technologies SLC ConnectReach User & Service Manual page 156

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Analog Trunks (Continued)
Key commands
(continued)
Procedure
4-70 Issue 4 June 2002
™
System
Busy-forward-line This command is used in conjunction with the line
Analog transmit
gain
Analog receive
gain
Load template
The copy-to-channel-data command only modifies LCR/DID channels. If the
begin and end commands include channels that are not switched, the copy-to-
channel-data command warns the user that data for those channels was not
modified.
After you have verified the required configuration, follow these steps to configure
analog trunks:
Step Procedure
At the Config prompt, enter the Analog trunk command:
1
(config)>
Analog trunk
The prompt changes to the Config:Analog trunk prompt.
(config:AnalogTrunk)>
option for incoming-routing . If the line specified
for receiving incoming calls is busy, the call will be
forwarded to the line specified in the busy-forward-
line command.
This command adjusts transmit signal levels to the
analog trunk from the FXS interface. Three settings
are available (0, –3, and –6 dB).
This command adjusts receive signal levels from the
analog trunk to the FXS interface. Three settings are
available (0, –3, –6, and –12 dB).
This command loads all of the configuration command
values that are stored in a template to the channel
being configured. This command allows multiple
channels to be set up identically without having to
enter each individual command for all channels.
363-208-050
(Continued on next page)