Lucent Technologies SLC ConnectReach User & Service Manual page 474

Configuration Examples
Examples of the Different Methods of Configuring the
® ™
SLC ConnectReach System
LCR/DID Configuration Example
(Continued)
Configuration
setting example
(continued)
Dialing table default
entries
B-16
Issue 4 June 2002
9. If there are any ten digit calls that are to be routed over the analog trunks
(ten-digit local call), enter the following command:
detect-insert 7 3 1AAAAAA|1BBBBBB| |ZZZZZZ
where AAAAAA through ZZZZZZ are the area code and exchanges to be
rerouted.
The following is a description of the dialing table default entries shown in the
following figure. The dialing table is displayed using the configure-dialing-
show-all commands.
Detect-table row 1 routes toll free calls (900 service is toll free to the recipient) to
output-row 3, which, in turn, routes them to trunk group 2.
363-208-050
(Continued on next page)