Lucent Technologies SLC ConnectReach User & Service Manual page 290

Installation
Connect Cables to the SLC ConnectReach System
Construct Cable Assemblies
T1, straight RJ-48
to DB-15
5-38 Issue 4 June 2002
(Continued)
The following figure illustrates the assembly of the required cable to connect the
SLC ConnectReach system using the T1 RJ-48 to DB-15 straight connection.
NOTE:
Note the following assembly requirements.
Use the same twisted pair for the TX-TIP and TX-RING.
3
Use the same twisted pair for the RX-TIP and RX-RING.
3
363-208-050
(Continued on next page)