Lucent Technologies SLC ConnectReach User & Service Manual page 112

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Network T1/DSX-1
Interface (Continued)
Procedure
(continued)
4-26 Issue 4 June 2002
™
System
Step Procedure
3 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT).
NOTE: If you change any of these commands, you must save the
configuration and reboot the SLC ConnectReach system using the
warm-start command for the new settings to take effect.
Stop! End of Procedure.
363-208-050