Lucent Technologies SLC ConnectReach User & Service Manual page 131

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Synchronous Interface
(Continued)
Configuring using
the PVC submenu
commands
(continued)
™
System
Step Procedure
At the Config:Frame-relay:PVCn prompt, enter SLA.
1
(config:Frame-relay:PVC1)> SLA
The prompt changes to the Config:FrameRelay:PVC1:SLA prompt.
(config:FrameRelay:PVC1:SLA)>
2 At the Config:FrameRelay:PVC1:SLA prompt, enter the appropriate
commands from the following table. The default setting for each
command appears in brackets.
Enter this
command...
enable
CIR
LatencyThreshold [0]...10000 ms
aboveCIRThreshold [0]...10000
belowCIRThreshold [0]...10000
...and specify this
value Comments
Enable SLA on this PVC.
[off], on
Specify committed information rate
(CIR)
[0]...2048KB
This is an SNMP trap parameter.
This trap is sent when the end-to-
end latency exceeds the defined
threshold.
This is an SNMP trap parameter.
This trap is sent when the above
CIR data delivery ratio drops below
the defined threshold. The number
specifies 1/100 of a percent (for
example, 10000 = 100%).
This is an SNMP trap parameter.
This trap is sent when the below
CIR data delivery ratio drops below
the defined threshold. The number
speicifes 1/100 of a percent (for
example, 10000 = 100%).
363-208-050
(Continued on next page)
Issue 4 June 2002 4-45