Lucent Technologies SLC ConnectReach User & Service Manual page 468

Configuration Examples
Examples of the Different Methods of Configuring the
® ™
SLC ConnectReach System
Customized Configuration Example
(Continued)
Example
(continued)
B-10
Issue 4 June 2002
(config)> dhc
(config:DHCP)> start-i
(config:DHCP)> end-i
(config:DHCP)> rivate-network off
(config:DHCP)> dns-server 199.188.177.5
(config:DHCP)> domain is .net
(config:DHCP)> !
(config)> snm
(config:SNMP)> snm -host 123.45.67.89
(config:SNMP)> cold-start on
(config:SNMP)> warm-start on
(config:SNMP)> link-down on
(config:SNMP)> link-u
(config:SNMP)> login-failures on
(config:SNMP)> !
(config)> dns
(config:DNS)> enable off
(config:DNS)> !
(config)> save
Verifying system configuration...
Do you really want to update the system NVRAM
configuration [n]\y: y
Updating Flash NVRAM... wait
DONE
(config)> exit
> cold-start
Warning: Voice and Data traffic will be interrupted...
continue? [n]\y: y
resetting...
NOTE:
Because this configuration has changed the beginning channels of both
voice and data ranges, the cold-start command must be used for the
new settings to take effect.
The next time you connect to the SLC ConnectReach system, you will be
prompted for a login name and password. If you want access to the full set of SLC
ConnectReach system configuration and monitoring commands, log in with the
carrier name and password ("sysadm" in the previous example).
211.22.33.2
211.22.33.54
on
363-208-050