Lucent Technologies SLC ConnectReach User & Service Manual page 230

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring QOS (Continued)
Example 2
4-144 Issue 4 June 2002
™
System
In this example, there are two SLC ConnectReach systems at two different
locations as shown in the following figure. Any packets originating from PC A will
be sent high priority and any packets destined for PC A will be high priority.
To configure the example shown in the figure, proceed as follows:
Step Procedure
1 For SLC ConnectReach system A:
At the Config:QOS prompt, enter the following commands:
(config:QOS)> enable on
(config:QOS)> qos add src 207.242.96.145
255.255.255.255
2 For SLC ConnectReach system B:
At the Config:QOS prompt, enter the following commands:
(config:QOS)> enable on
(config:QOS)> qos add dst 207.242.96.145
255.255.255.255
363-208-050
(Continued on next page)