Table of Contents
Advertisement
Preinstallation Planning
Configuration and Installation Process
Quickstart Configuration
Description
Quickstart
configuration
planning process
The quickstart configuration is for channel bank configurations only where default
settings are used for all or most of the configuration parameters. Refer to
Appendix B, "Configuration Examples", for a quickstart example of the channel
bank configuration. In this type of installation, there are only a few configuration
parameters that you need to set.
Unless stated otherwise, the numbered steps below are in the same order as the
numbered areas on the Preconfiguration Worksheet presented later in this
chapter. Default values, where applicable, are shown in parentheses below and in
bold on the worksheet. For detailed information about parameters and the
possible values, refer to Chapter 4, "Configuring the SLC ConnectReach System".
1.
Determine whether the Network T1/DSX-1 default values match the carrier
configuration of the T1 line. Since the SLC ConnectReach system will
always connect to a
SLC-2000 Access System, the Network T1/DSX-1 framing format and line
coding will be extended superframe (ESF) and bipolar 8 zero substitution
(B8ZS), respectively.
2.
If the SLC ConnectReach system will have a T1 connection to the site
phone system, determine whether the Secondary T1/DSX-1 default values
match the configuration of the T1 connection to the phone system.
3.
DS0 provisioning (voice and data channel assignments). The default
channel assignments correspond to the actual hardware configuration. If
these are appropriate, you do not need to set or change the channel
assignments.
— Number of analog voice channels (channels set according to actual
hardware).
— Number of secondary T1/DSX-1 voice channels (none).
— Number of data channels (none).
363-208-050
(Continued on next page)
Issue 4
June 2002
3-5
Advertisement
Chapters
Table of Contents
