Lucent Technologies SLC ConnectReach User & Service Manual page 93

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Making Connections to the SLC
ConnectReach System (Continued)
Connection at the Connecting a Computer Directly to the RS-232 Port
RS-232 port
Make the following connections when using a local computer to configure the SLC
ConnectReach system:
™
System
™
System for Initial
Step Procedure
1 Connect one end of a null modem cable to the serial port on the
computer.
2 Connect the other end of the null modem cable to the
RS-232 connector on the SLC ConnectReach system, shown in the
following figure.
NOTE: The RS-232 connector is a data terminal equipment (DTE)
device and requires a null modem cable when connected to a
computer.
Stop! End of Procedure.
363-208-050
(Continued on next page)
4-7
Issue 4 June 2002