Lucent Technologies SLC ConnectReach User & Service Manual page 249

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Using Template Archive (Continued)
Procedure
(continued)
™
System
Step Procedure
5 Enter all the configuration parameters required for the remote SLC
ConnectReach system. For more information on setting parameters of
specific submenus, see the pertinent sections in this chapter.
WARNING:
Do not enter the save command at this point as you may not be
able to connect to the FTP server due to possible changes in the
network configuration.
6 When all the configuration parameters have been set, upload the file to
the FTP server by entering the upload command from the config:template
prompt.
(config:template)> upload
7 To return to the normal operational mode, disable the template-archive by
entering:
(config:template)> enable off
from the config:template prompt.
8 Save the template archive settings by entering the save command. This
will put the SLC ConnectReach system in the normal functioning mode.
Issue 4 June 2002 4-163
363-208-050