Displaying A Time-Stamped Log Of Events - Lucent Technologies SLC ConnectReach User & Service Manual

Software Upgrade, Maintenance, and Trouble Clearing
Trouble Clearing Procedures
Displaying a Time-Stamped Log of
Events
Entering the log
command
9-26 Issue 4 June 2002
The log command is used to display a time-stamped log of events that occur in
the SLC ConnectReach system, such as logins, HTTP or console commands, and
errors. You can also display a log of the T1 line that records information such as
alarms and line-up or line-down conditions.
At the Main Menu prompt, enter the log command followed by an option obtained
from the following table.
For example:
> log eventdump
To...
Display the log for the SLC
Display the log for the T1 line
Clear the log for the SLC ConnectReach system
Clear the log for the T1 line
Clear the log for both the SLC ConnectReach system and
the T1 line
Stop all logging
Resume all logging
Determine whether the log is running or stopped
® ™
ConnectReach system
363-208-050
Enter this command...
log eventdump
log t1dump
log clear event
log clear t1
log clear all
log stop
log continue
log status
(Continued on next page)