Lucent Technologies SLC ConnectReach User & Service Manual page 157

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Analog Trunks (Continued)
Procedure
(continued)
™
System
Step Procedure
2 Use the begin and end commands to specify the analog trunk or range of analog
trunks to which subsequent changes will apply.
NOTE:
The channel numbers specified in the begin and end commands
refer to the voice channels (lines) on the VOICE CHANNELS port
(50-pin telephony type connector). A foreign exchange office (FXO)
type voice interface card should be used for these channels.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-71