Lucent Technologies SLC ConnectReach User & Service Manual page 23

About This Information Product (IP)
Product Safety
Electrostatic Discharge (ESD)
(Continued)
Grounding using wrist
strap
To reduce the possibility of ESD damage, the SLC ConnectReach system
cabinet is equipped with a ground stud to enable personnel to ground
themselves using a wrist strap (refer to the following figure) with a minimum
resistance of 250 k-ohms while handling circuit packs or working on the system.
The ground stud is located on the front of the cabinet between the POWER
connector and the VOICE CHANNELS connector. An alligator clip adapter must
be attached to the plug on the end of the wrist strap cable to enable connection
to the ground stud.
363-208-050
Issue 4 June 2002 xix