Lucent Technologies SLC ConnectReach User & Service Manual page 100

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Using the SLC ConnectReach System
Utility (Continued)
At the Main Menu prompt, you can enter a set of commands called the Main Menu
Entering commands
commands.
These commands are not case sensitive. You can abbreviate a command to the
minimum number of characters that uniquely identify the command. For example,
you can enter the configure command by typing the first three characters:
> con
After you enter a command, the SLC ConnectReach system Utility either
executes the command or displays a submenu command prompt. For example, if
you enter the configure command, the Config submenu prompt appears:
(config) >
At the Config prompt, you can enter the commands to configure specific sets of
commands. Each set has its own submenu, where a new prompt is displayed. For
example, when you enter the command to configure the Ethernet interface, the
prompt changes to:
(config:Ethernet)>
After completing the configuration for each component, you return to the Config
menu by entering the exit command or an exclamation point (!) (quoted as "\ |"
through the SLC-2000 Access System CIT)
Getting online help At any time, you can display a list of the commands in the current menu by typing
a question mark (?). If you enter a question mark after partially typing a command,
the options for that specific command are displayed. Otherwise, a list of the
currently available commands is displayed. The default settings are enclosed in
brackets.
In addition to the question mark, each menu has a help command. The help
command displays a brief explanation of each command on the current menu.
4-14
Issue 4 June 2002
™
System
™
System for Initial
.
(Continued on next page)
363-208-050