Lucent Technologies SLC ConnectReach User & Service Manual page 209

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring NAT and PAT (Continued)
Procedure
(continued)
™
System
Step Procedure
3 Each submenu command, Dynamic , Static , and PassThru , has four
groups available for setting allocations. The following procedures explain
the use of these three commands:
Dynamic
1. At the specific submenu, enter the group to be configured.
For example:
(config:NAT:Dynamic) > 1
The prompt changes to the submenu-group that is to be
configured. For example:
(config:NAT:Dynamic:Group1) >
2. At the submenu-group prompt, enter the appropriate
command from the following Dynamic configuration
commands table.
Enter this ...and specify
command... this value
enable [off], on
IN-Start 0.0.0.0
IN-End 0.0.0.0
OUT 0.0.0.0
PAT ....
Show
Clear
Help
Comments
Enables dynamic allocation.
Enter the starting IP addresses for the range.
Enter the ending IP addresses for the range.
Enter the starting IP addresses for the range.
Submenu for Port Address Translation
Shows connections associated with specified
[all], udp, tcp,
icmp parameter for this dynamic group.
Clear connections associated with specified
[all], udp, tcp,
icmp parameter for this dynamic group.
Access online assistance
(Continued on next page)
Issue 4 June 2002 4-123
363-208-050