Lucent Technologies SLC ConnectReach User & Service Manual page 165

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Lines (Continued)
Procedure
(continued)
™
System
Step Procedure
For setting BOX features enter the BOX-features command:
4
(config:Line)>
A description of the BOX-features command is presented in the
following section.
5 Make the necessary configuration changes. Refer to the table in the
following section entitled "BOX features description", for a description of
these commands.
For setting feature codes, enter the feature-codes command:
6
(config:Line)>
A description of the feature-codes command is presented in the following
section.
7 Make the necessary configuration changes. Refer to the table in the
section entitled "Feature codes description", located later in this chapter,
for a description of these commands.
8 Use the copy-to-channel-data command to update line commands
from begin to end.
9 Use the Show-all command to see the actual channel configuration.
10 Type exit or an exclamation point (!) (quoted as "\ |" through the SLC-
2000 Access System CIT) to return to the Config menu.
NOTE: The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
BOX-features
feature-codes
363-208-050
(Continued on next page)
Issue 4 June 2002 4-79