®
Configuring the SLC
ConnectReach
Using the Configuration Commands
Configuring QOS (Continued)
Procedure
(continued)
Example 1
4-142
Issue 4
June 2002
™
System
Step
Procedure
3
When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT).
NOTE: The new command value takes effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new value.
Stop! End of Procedure.
The QOS example in the following figure describes a scenario where any packet
originating from PC A will be treated as high priority with guaranteed service.
363-208-050
(Continued on next page)