Lucent Technologies SLC ConnectReach User & Service Manual page 429

Software Upgrade, Maintenance, and Trouble Clearing
Maintenance Procedures
Using the Archive Command to Upload/
Download Configuration Settings
(Continued)
Downloading an
archived
configuration over
the network from an
FTP server
Use the following procedure to download archived configuration settings from an
FTP server to a SLC ConnectReach system over the network:
Step Procedure
1 At the Main prompt, enter the archive command:
> archive
2 At the Archive prompt, enter the net-download command:
(archive)> net-download
3 At the Archive:Net-download prompt, enter the commands shown in the
following table.
Enter this
command...
server-ipaddr name, ip-addr
filename
user
password
4 To start the download, enter the do-download command:
(archive)> do-download
5 After the download completes, save your changes:
(archive)> save
(archive)> exit
...and specify this
value Comments
Host name or IP address of the FTP
server on which the configuration is
stored.
Pathname of the file on the FTP
pathname
server.
Username valid on the FTP server.
username
Enter the password for the
password
username.
363-208-050
(Continued on next page)
Issue 4 June 2002 9-15