Using The Slc Connectreach System Utility - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Using the SLC ConnectReach System
Utility
After the computer terminal is connected to the SLC ConnectReach system using
Description
a terminal emulation application, the SLC ConnectReach system activates the
utility program which allows the computer to communicate with the SLC
ConnectReach system to issue commands and receive messages from the SLC
ConnectReach system. During start-up, the utility causes a series of session start-
up messages and a command prompt to appear in the console window. This
prompt, a greater-than symbol ( > ), is the SLC ConnectReach system Utility Main
Menu prompt, as shown in the following figure.
™
System
™
System for Initial
NOTE:
These messages are not displayed if the power was applied before the
terminal program was started. The Main Menu prompt ( > ) will be the only
thing appearing on the screen. To display these messages, enter the
version command.
NOTE:
The following screen display is only an example of what may appear on
your console window. The actual display will depend on the version of
software in the SLC ConnectReach system. Refer to the appropriate
software release description for additional information.
363-208-050
(Continued on next page)
4-13
Issue 4 June 2002