Lucent Technologies SLC ConnectReach User & Service Manual page 358

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for a T1 Interface
(Continued)
Clearing statistics
on a T1 line
Displaying status on
a T1 line
7-24
Issue 4 June 2002
At the statistics:T1 prompt, enter either the clearReport network or
clearReport secondary/fractional
to select the network T1 line or the secondary/fractional T1/DSX-1 line,
respectively. For example:
(statistics:T1)> clearReport network
The SLC ConnectReach system maintains two sets of statistics records, one
called the carrier database and the other called the user database. Initially, both
sets are identical. When you clear statistics, you clear only the user database.
The entire carrier database is always retained, so that statistics records are
available even if the user database is cleared.
At the statistics:T1 prompt, enter either the statusReport network or
statusReport secondary/fractional command to select the network T1/
DSX-1 line or the secondary/fractional T1/DSX-1 line, respectively. For example:
(statistics:T1)> statusreport network
A report similar to the following example is displayed for the T1 line you specified:
Network T1 LINE STATUS
Loss of Signal
Unavailable State
Loss of Frame
Receive AIS
Receive RAI
Transmit RAI
Transmit AIS
Loopback Status
: NO
: NO
: NO
: NO
: NO
: NO
: NO
: OFF
363-208-050
(Continued on next page)