Using The Configuration Commands; Basic Procedure For Using The Configuration Commands - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach

Using the Configuration Commands

Using the Configuration Commands
Basic Procedure For Using the
Configuration Commands
Introduction
™
System
A list of all configuration menu commands is given in the following table. The
command(s) associated with a particular feature will appear only if that feature is
available (activated).
To...
Configure the Network T1/DSX-1 interface to the carrier CO
Configure the Secondary T1/DSX-1 or Fractional T1/DSX-1
interface
Specify the split between voice and data T1 DS0s and to specify
emulated channel units
Configure the synchronous interface
Configure the Ethernet interface to the local area network (LAN) Ethernet
Configure telephony functionality for channel-bank mode
Configure digital trunks
Configure analog trunks
Configure lines
Configure (Map) Line Extensions
Configure dialing
Configure Attached Voice Mail System
Configure user names and passwords
Configure the Internet protocol (IP) address allocation service
Configure the simple network management protocol (SNMP)
service
Configure the default route(s)
Configure network address translation (NAT)
Configure Firewall support
Configure network time protocol (NTP)
Configure domain name service (DNS)
Configure quality of service (QOS)
Configure a Telnet port
Configure a Web browser port
Set or clear MAC/IP address mapping
363-208-050
Enter this command...
Network-t1
Secondary-t1 or
Fractional-t1
DS0-Provisioning
Synchronous-
interface
Channel-bank
Digital-trunk
Analog-trunk
Line
Map-Extensions
Dialing
Voice-Mail
Password
DHCP
SNMP
Route
NAT
FIREWALL
NTP
DNS
QOS
Telnet
HTTP
ARP
(Continued on next page)
Issue 4 June 2002 4-17