Lucent Technologies SLC ConnectReach User & Service Manual page 271

Installation
Interface Card Installation
Optional Circuit Card Installation
(Continued)
DSP or Fractional
T1/DSP
combination
circuit card
installation
procedure
(continued)
Step Procedure
Refer to the following figure and install the metal standoff over the
7
threaded stud on the motherboard (located near header P31)
8 Align the connectors on the bottom of the DSP or fractional T1/DSP
combination card with the connector pins on the motherboard and make
sure that the hole on the edge of the circuit card is located over the
standoff. Press gently on the top of the circuit card until the connector pins
on the motherboard are fully seated in the circuit card connectors.
9 Secure the DSP or fractional T1/DSP combination cards to the standoff
using the hex nut provided.
363-208-050
.
(Continued on next page)
Issue 4 June 2002 5-19