Lucent Technologies SLC ConnectReach User & Service Manual page 151

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Digital Trunks (Continued)
Key commands
(continued)
Procedure
™
System
Load template
The copy-to-channel-data command only modifies LCR/DID channels. If
the begin and end commands include channels that are not LCR/DID, the
copy-to-channel-data warns the user that data for those channels was not
modified.
The Show-all command only displays all digital trunk configuration.
After you have verified the required configuration, follow these steps to configure
digital trunks:
Step Procedure
1 Before you can set the desired channels in the digital trunk menu, you will need to
unconfigure them in the channel bank menu. Refer to the previous table
containing channel bank configuration commands.
At the Config prompt, enter the Digital Trunk command:
2
(config)>
Digital-trunk
The prompt changes to the Config:Digital Trunk prompt.
(config:DigitalTrunk)>
Use the begin and end commands to specify the digital trunk or range of digital
3
trunks to which subsequent changes will apply.
NOTE: The channel numbers specified in the begin and end
commands refer to the Network T1/DSX-1 DS0s. The range of
available DS0s is limited by the analog-begin and analog-end
commands in the DS0 provisioning menu excluding the channels
provisioned for the channel bank mode.
This command loads all of the configuration command
values that are stored in a template to the channel
being configured. This command allows multiple
channels to be set up identically without having to
enter each individual command for all channels.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-65