Lucent Technologies SLC ConnectReach User & Service Manual page 101

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Using the SLC ConnectReach System
Utility (Continued)
When you are finished configuring the SLC ConnectReach system, you should
Exiting the Utility
exit the Utility by using the exit command at the Main Menu prompt.
The SLC ConnectReach system Utility allows only one management session at a
time. Exiting the Utility allows another administrator to connect to the SLC
ConnectReach system and configure or monitor it.
A SLC ConnectReach system management session can override another session
in the following ways:
™
System
™
System for Initial
If another session is already in progress, and you start a new session, you
3
will be notified that another user is logged in and asked whether you wish
to override that user.
If you have a management session in progress, and another administrator
3
overrides your session, you will be notified that your session has been
overridden.
363-208-050
(Continued on next page)
4-15
Issue 4 June 2002