Lucent Technologies SLC ConnectReach User & Service Manual page 396

Configure/Monitor and Upgrade Software for the SLC
ConnectReach System Using a Web Browser
Executing Commands from the Main Menu
Displaying Selected Menu Screens
(Continued)
Display config
submenu
(continued)
8-8
Issue 4 June 2002
Step Procedure
3 Change the configuration settings as necessary, and then click the
Update button in the Configuration screen to store the new settings in a
temporary memory buffer in the SLC ConnectReach system.
4 To return to the Config screen, click the Previous Page command at
the bottom of the Config Network-T1 screen.
5 To save your settings in nonvolatile random access memory (NVRAM) in
the SLC ConnectReach system, click the save command in the Config
screen.
6 To return to the Main Menu, click the Main Menu command at the bottom
of the Config screen.
Some parameters take effect as soon as you click the save command,
but others require that you reboot the SLC ConnectReach system. See
the detailed descriptions of configuration parameters in Chapter 4,
"Configuring the SLC
whether the parameters require a reboot to take effect.
NOTE:
In most cases, if a reboot is required, you click the warm-start
command. However, if you change the beginning channel number
of any range in the DS0 Provisioning menu and do a warm-start,
the system will automatically prompt you that it will perform a cold-
start. Refer to the section entitled "Using a Web Browser to Reboot
the SLC ConnectReach system", located later in this chapter, for
information on the warm-start and cold-start commands.
Stop! End of Procedure.
® ™
ConnectReach System", for information on
363-208-050
(Continued on next page)