Construct Cable Assemblies - Lucent Technologies SLC ConnectReach User & Service Manual

Installation
Connect Cables to the SLC ConnectReach System

Construct Cable Assemblies

Introduction
Standard cables
5-34 Issue 4 June 2002
You must provide the cable assemblies for the SLC ConnectReach system.
The following cables are standard and readily available.
Standard 10Base-T Ethernet cable (RJ-45) for connection to the local
3
Ethernet network (refer to the following figure for pin designations)
Telco cable (standard Telco 50-pin) for connection to the punch-down block
3
for analog voice channels.
Ground wire with ring lug for frame ground (optional)
3
DC power cable (optional).
3
363-208-050
(Continued on next page)